Doing more is what trying to improve the donation rate from the current less that. I see it has been upgraded to use https recently (it used to be http) and likely the passwords all reset (I had to reset mine anyway!) so work is being done in the background as time and funding permit. There is no staging environment, it has had no (or at least very little) maintenance for 4 years and changes have to be done on the live web page. At present however the web site is fragile.
I think it used to be there, and probably will be again. I really think that Frizing is a good initiative and I think it would be smart to bring the donate button on to the Main page or at least somewhere in the forum. Note as usual, the mounting holes are only on silkscreen in the part, if you want holes on a board you make, in the sketch you need to drag a hole from the pcb area of core parts in to the sketch and set its diameter to 3mm and place it over the hole in silkscreen so the hole will be drilled in the board (if you don’t want the mounting holes leave it as is.) I have replaced the part posted above with the corrected part. If you can measure how far off the mounting holes are in x and y for each hole I can move them in pcb to match the real position. The header holes should all match exactly, but the mounting holes may be off by a bit.
The easiest way to fix that is for you to print out the pcb view at 1:1 scale (preferably on an clear overhead transparency) and compare it to the real board. I split the difference between the two sets of mounting holes, but the position likely isn’t exactly correct yet. psd are slightly shorter in Y than the measurements in the dimension drawing posted above. 1in boundaries) the mounting holes in the. Unfortunately when I scaled it so the headers are correct (they are on exactly. psd to a jpg (which Inkscape will import unlike the psd) and imported it in to the Inkscape breadboard view.
0 kommentar(er)
